Chainsaws for Trees and Logs

Chainsaws for felling trees and cutting logs, an older section wording kept for reference.

Felling a tree and bucking the logs that come off it are two different jobs done with one saw. This is an older wording used on the site for saws that cover both.

We have 22 saws tagged for this job, 16 of them current. The short answer:

  • Trunks up to about 35 cm: a 40 cm bar with 45 cc or more behind it.
  • Bucking the logs afterwards: the same saw, a sharp chain and a sawhorse.
  • Anything near a building or a road: an arborist, not a hire saw.

This is an older wording of the same job. The fuller listing is chainsaws for cutting firewood.

MS 881 Petrol Chainsaw

MS 881 Petrol Chainsaw

On paper the STIHL MS 881 Petrol Chainsaw comes down to petrol power. The specification lists an output of 6.40 kW, a 6.4W motor, a listed weight of 9.9 kg. It is fitted with low-kickback chain. Petrol suits firewood, felling and work away from power. Budget for a 50:1 two-stroke mix unless the manual says …

MS 881 Petrol Chainsaw Read More »

Read more »

MS 661 C-M Petrol Chainsaw

MS 661 C-M Petrol Chainsaw

On paper the STIHL MS 661 C-M Petrol Chainsaw comes down to petrol power. The specification lists a 5.4W motor. It is fitted with low-kickback chain. Petrol suits firewood, felling and work away from power. Budget for a 50:1 two-stroke mix unless the manual says otherwise, keep the bar oil topped up, and do not …

MS 661 C-M Petrol Chainsaw Read More »

Read more »

MS 500i Petrol Chainsaw

MS 500i Petrol Chainsaw

On paper the STIHL MS 500i Petrol Chainsaw comes down to petrol power. The specification lists an output of 5 kW, a 5W motor, a listed weight of 6.2 kg. It is fitted with low-kickback chain. Petrol suits firewood, felling and work away from power. Budget for a 50:1 two-stroke mix unless the manual says …

MS 500i Petrol Chainsaw Read More »

Read more »

Saws for felling trees and cutting logs

Current models tagged for this job, shortest bar first.

ModelBrandPower
MSA 140 C-B Cordless ChainsawStihlBattery
Ryobi OCS1830 ReviewRyobiElectric
MSA 140 C-B Cordless Chainsaw – battery and charger setsStihlBattery
MSA 120 C-B Cordless ChainsawStihlBattery
Einhell 4501780 GE-LC ReviewEinhellBattery
Makita UC3541A/2 ReviewMakitaCorded
Murray IQ18DCSK ReviewMurrayBattery
Gowe Strong power 105ccGowePetrol
Greenworks Battery Chainsaw GD24X2CS36GreenworksBattery
MS 462 C-M Petrol ChainsawStihlPetrol
MS 500i W Petrol ChainsawStihlFuel injection / Petrol

Felling needs a bar longer than the trunk

A hinge you can cut in one pass is what controls the direction a tree falls. Working around a short bar from both sides makes an even hinge much harder, which is why felling asks for a bar longer than the trunk rather than a technique that compensates for a short one.

Then add the escape route, the back cut and a look overhead for dead limbs. Felling is the part of chainsaw work where the saw matters least and the planning matters most.

Bucking is a different problem

Once the tree is down the work becomes repetition, and what matters is a sharp chain, a comfortable working height and keeping the bar out of the soil. A log supported at both ends closes on the cut from above, so start underneath; a log supported at one end does the reverse.

Browse another way

By power source: petrol, cordless or corded. By cutting length: 12 inch, 14 inch, 16 inch or 18 inch.

Chainsaws for Trees and Logs FAQs

What size chainsaw do I need to fell a tree?

A bar longer than the trunk diameter, so 40 cm for trunks up to about 35 cm and 45 to 50 cm beyond that, with 50 cc or more behind it. Technique matters more than the saw: the hinge, the back cut and an escape route decide where it lands.

Can I fell a tree in my own garden?

Using the saw needs no licence on your own land, but the tree may be protected by a Tree Preservation Order or conservation area rules, and felling licences apply to volume felling. Check with the council first, and call an arborist for anything near a building, a road or a boundary.

How do you stop the bar pinching when bucking?

Read where the weight will move. Supported at both ends, the log closes on the cut from above, so undercut first. Supported at one end, it opens from above. Plastic wedges keep a cut open, and a sawhorse removes the problem for smaller logs.